Switch Settings; Station Address Setting Switch (Stn-H, Stn-L); Station Address Setting Switch (Stn-H、Stn-L) - Toshiba nv Series Instruction Manual

Chapter3Settings
3.1

Switch Settings

The switches for the operation mode and station address are found in the front panel of the EN655
module. The switch settings will be explained in the following subsections.
3.1.1 Station address setting switch (STN-H、STN-L)
the station address of the Ethernet network.
The station address (1 to 254) assigned during system configuration will be set using
hexadecimal code. All nodes in the system will each be assigned different addresses.
the equivalent in hex is '1C'(h), perform the settings as follows.
6F8C1566
16 16
◆ IMPORTANT
・Please perform switch settings of the operation mode and station address before turning the
power supply on.
The station address setting switches are hexadecimal rotary-type switches used to set
For details on station address settings, refer to "3.2 Network Parameter Settings."
Table 3-1 shows the station address settings.
Table 3-1 Station Address setting
Name
STN-H
STN-L
(Note) The symbol (h) implies hexadecimal notation.
REMARK
・ For the settings, use a small flat-blade screwdriver (tip width：2.0~2.5mm thickness:
0.5~0.6mm).
Set the station address in hexadecimal notation. For instance, given the address is 28,
STN-H: '1'
STN-L: 'C'
Refer to 'Decimal-hexadecimal conversion table' for more details.
NOTE
・ Make sure that there are no duplication of node addresses.
Setting
Setting Range：01～FE(h)
STN-H(high order address)：0～F(h)
STN-L(low order address)：0～F(h)