Toshiba nv Series Instruction Manual page 52

Chapter 4 Operation
The switches of the product have been adjusted for the system at the site adjustment.
For normal operation, do not change any switch settings other than the ones the
customer needs to operate.
■ Checking before operation
Before turning on the power and operating the product, check again that the following
are as described in this instruction manual:
■ Startup operation
When the power supply module is turned on, the module starts running automatically.
When the EN655 module is up and running, check that it is operating correctly by
referring to "Table 1-1 Display details on the state display LED and normal display" on
page 5.
If the module doesn't start up or if the operation is erroneous, stop using the product
immediately and contact one of Toshiba's service representatives.
■ Shutdown operation
To shut down, turn off the power of the power supply module.
38
6F8C1566
Avoid incorrect setting.
CAUTION
The product does not operate normally if the switches are
set incorrectly. Read this instruction manual thoroughly
to avoid incorrect setting.
Stop using immediately when an error occurs.
CAUTION
When an error occurs such as unable to turn on the
power, stop using and contact one of Toshiba's service
representatives.
・ Switch setting
・ Installation
・ Wiring
NOTE
・Checking the switch settings
Use the engineering tool to check the switch settings (station address setting switch and
operation mode setting switch).
Prohibited
Mandatory