Toshiba nv Series Instruction Manual page 59

Loading the System Log (using USB connection)
■
Engineering
Tool（PC）
USB Cable
P P E
S U N
6 M 6
9 1 5
5
3 4
Figure 5-7 USB connection with the engineering tool
１
From the engineering tool, connect the USB cable to EN655's USB connector.
２
Start the engineering tool.
３
Open <Tool><Communication Parameter Settings>and make sure that the
communication method is set as RS-232C/ USB.
Figure 5-8 Communication Parameter Settings
NOTE
When using the engineering tool using USB communication method for the first time, there is
a need to install the USB driver. Refer to the Unified Controller nv series type1 light Controller
Unit User's Manual – Basic Hardware (6F8C1497) for more details.
・・・
Unified Controller nv series Ethernet Module (EN655) Instruction Manual
Chapter 5 Troubleshooting
45