Toshiba nv Series Instruction Manual page 55

■ Loading the System Log (using the Ethernet)
Load the log using configuration below.
Engineering Tool
(PC)
Ethernet
Figure 5-1 System Configuration Example
Connect the controller and the engineering tool by Ethernet.
Start the engineering tool.
Open <Tool><Communication Parameter Settings>and make sure that the
communication method is set as Ethernet.
Figure 5-2 Communication Parameter Settings
Ｅ
P P
S U N
6 M 6
・・・
9 1 5
5
3 4
Unified Controller nv series Ethernet Module (EN655) Instruction Manual
Chapter 5 Troubleshooting
41