Toshiba nv Series Instruction Manual page 44

Chapter3Settings
Read using USB connection
■
１
２
３
6F8C1566
30 30
Engineering
Tool（PC）
USB Cable
P P E
S U N
6 M 6
・・・
9 1 5
5
3 4
Figure 3-13 USB connection with the engineering tool
From the engineering tool, connect the USB cable to EN655's USB connector.
Start the engineering tool.
Open <Tool><Communication Parameter Settings>and make sure that the
communication method is set as RS-232C/ USB.
Figure 5-8 Communication Parameter Settings
NOTE
When using the engineering tool using USB communication method for the first time, there is
a need to install the USB driver. Refer to the Unified Controller nv series type1 light Controller
Unit User's Manual – Basic Hardware (6F8C1497) for more details.