NetApp AFF A200 System Documentation page 765

If you see...
The login prompt
Waiting for giveback...
7. Connect the console cable to the partner node.
8. Give back the node using the
9. At the cluster prompt, check the logical interfaces with the
If any interfaces are listed as "false", revert those interfaces back to their home port using the
command.
revert
10. Move the console cable to the repaired node and run the
versions.
11. Restore automatic giveback if you disabled it by using the
-auto-giveback true
Restore OKM, NSE, and NVE as needed - AFF A700s
Once environment variables are checked, you must complete steps specific to systems
that have Onboard Key Manager (OKM), NetApp Storage Encryption (NSE) or NetApp
Volume Encryption (NVE) enabled.
Determine which section you should use to restore your OKM, NSE, or NVE configurations:
If NSE or NVE are enabled along with Onboard Key Manager you must restore settings you captured at the
beginning of this procedure.
• If NSE or NVE are enabled and Onboard Key Manager is enabled, go to
when Onboard Key Manager is
• If NSE or NVE are enabled for ONATP 9.5, go to
9.5 and earlier.
• If NSE or NVE are enabled for ONTAP 9.6, go to
9.6 and later.
Option 1: Restore NVE or NSE when Onboard Key Manager is enabled
Steps
1. Connect the console cable to the target node.
2. Use the
boot_ontap
3. Check the console output:
762
Then...
Go to the next Step.
a. Log into the partner node.
b. Confirm the target node is ready for giveback with the
failover show
storage failover giveback -fromnode local
command.
enabled.
command at the LOADER prompt to boot the node.
command.
net int -is-home false
command to check the ONTAP
version -v
storage failover modify -node local
Option 2: Restore NSE/NVE on systems running ONTAP
Option 3: Restore NSE/NVE on systems running ONTAP
storage
command.
command.
net int
Option 1: Restore NVE or NSE