NetApp AFF A200 System Documentation page 303

If any interfaces are listed as false, revert those interfaces back to their home port using the
command.
revert
7. Move the console cable to the target node and run the
versions.
8. Restore automatic giveback if you disabled it by using the
-auto-giveback true
9. Use the
storage encryption disk show
10. Use the
security key-manager key query
keys that are stored on the key management servers.
◦ If the
Restored
process.
◦ If the Key Manager type
use the
security key-manager external restore
authentication keys.
If the command fails, contact Customer Support.
◦ If the
Key Manager type
use the
security key-manager onboard sync
Use the security key-manager key query to verify that the
authentication keys.
11. Connect the console cable to the partner node.
12. Give back the node using the
13. Restore automatic giveback if you disabled it by using the
-auto-giveback true
Return the failed part to NetApp - AFF A300
After you replace the part, you can return the failed part to NetApp, as described in the
RMA instructions shipped with the kit. Contact technical support at
463-8277 (North America), 00-800-44-638277 (Europe), or +800-800-80-800
(Asia/Pacific) if you need the RMA number or additional help with the replacement
procedure.
Chassis
Replace the chassis - AFF A300
To replace the chassis, you must move the power supplies, fans, and controller modules
from the impaired chassis to the new chassis, and swap out the impaired chassis from
the equipment rack or system cabinet with the new chassis of the same model as the
impaired chassis.
All other components in the system must be functioning properly; if not, you must contact technical support.
300
command.
column = yes/true, you are done and can proceed to complete the replacement
= external
= and the
onboard
storage failover giveback -fromnode local
command.
version -v
storage failover modify -node local
at the clustershell prompt, to review the output.
command to display the key IDs of the authentication
and the Restored column = anything other than yes/true,
command to restore the key IDs of the
column = anything other than yes/true,
Restored
command to re-sync the Key Manager type.
Restored
storage failover modify -node local
command to check the ONTAP
column =
yes/true
command.
NetApp Support, 888-
net int
for all