NetApp AFF A200 System Documentation page 971

Restore NSE/NVE on systems running ONTAP 9.6 and later
Steps
1. Connect the console cable to the target node.
2. Use the
boot_ontap
3. Check the console output:
If the console displays...
The login prompt
Waiting for giveback...
4. Move the console cable to the partner node and give back the target node storage using the
failover giveback -fromnode local -only-cfo-aggregates true local
◦ If the command fails because of a failed disk, physically dis-engage the failed disk, but leave the disk in
the slot until a replacement is received.
◦ If the command fails because of an open CIFS sessions, check with customer how to close out CIFS
sessions.
Terminating CIFS can cause loss of data.
◦ If the command fails because the partner "not ready", wait 5 minutes for the NVMEMs to synchronize.
◦ If the command fails because of an NDMP, SnapMirror, or SnapVault process, disable the process. See
the appropriate Documentation Center for more information.
5. Wait 3 minutes and check the failover status with the
6. At the clustershell prompt, enter the
interfaces that are not on their home node and port.
If any interfaces are listed as false, revert those interfaces back to their home port using the
command.
revert
7. Move the console cable to the target node and run the
versions.
8. Restore automatic giveback if you disabled it by using the
-auto-giveback true
9. Use the
storage encryption disk show
10. Use the
security key-manager key query
keys that are stored on the key management servers.
◦ If the
Restored
process.
◦ If the
Key Manager type
use the
security key-manager external restore
968
command at the LOADER prompt to boot the node.
net int show -is-home false
command.
column = yes/true, you are done and can proceed to complete the replacement
=
external
Then...
Go to Step 7.
a. Log into the partner node.
b. Confirm the target node is ready for giveback
with the
storage failover show
storage failover show
version -v
storage failover modify -node local
at the clustershell prompt, to review the output.
command to display the key IDs of the authentication
and the column = anything other than yes/true,
Restored
command to restore the key IDs of the
command.
command.
command to list the logical
command to check the ONTAP
command.
storage
net int