NetApp AFF A200 System Documentation page 892

1. If the replacement node is not at the LOADER prompt, halt the system to the LOADER prompt.
2. On the healthy node, check the system time:
The date and time are given in GMT.
3. At the LOADER prompt, check the date and time on the replacement node:
The date and time are given in GMT.
4. If necessary, set the date in GMT on the replacement node:
5. If necessary, set the time in GMT on the replacement node:
6. At the LOADER prompt, confirm the date and time on the replacement node:
The date and time are given in GMT.
Step 2: Verify and set the HA state of the chassis
You must verify the
to match your system configuration.
1. In Maintenance mode from the new controller module, verify that all components display the same
state:
ha-config show
The HA state should be the same for all components.
2. If the displayed system state of the controller module does not match your system configuration, set the
state for the controller module:
The value for HA-state can be one of the following:
◦
ha
◦
mcc
◦
mccip
◦
non-ha
3. If the displayed system state of the controller module does not match your system configuration, set the
state for the controller module:
4. Confirm that the setting has changed:
Step 3: Run diagnostics
After you have replaced a component in your system, you should run diagnostic tests on
that component.
Your system must be at the LOADER prompt to start diagnostics.
All commands in the diagnostic procedures are issued from the node where the component is being replaced.
1. If the node to be serviced is not at the LOADER prompt, reboot the node:
state of the controller module and, if necessary, update the state
HA
ha-config modify controller ha-state
ha-config modify controller ha-state
ha-config show
show date
set date mm/dd/yyyy
set time hh:mm:ss
show date
show date
system node halt -node
HA
HA
HA
889