NetApp AFF A200 System Documentation page 1123

9. Confirm the target node is ready for giveback with the
10. Giveback only the CFO aggregates with the
-only-cfo-aggregates true
◦ If the command fails because of a failed disk, physically dis-engage the failed disk, but leave the disk in
the slot until a replacement is received.
◦ If the command fails because of an open CIFS sessions, check with customer how to close out CIFS
sessions.
Terminating CIFS can cause loss of data.
◦ If the command fails because the partner "not ready", wait 5 minutes for the NVMEMs to synchronize.
◦ If the command fails because of an NDMP, SnapMirror, or SnapVault process, disable the process. See
the appropriate Documentation Center for more information.
11. Once the giveback completes, check the failover and giveback status with the
and
storage failover show-giveback
Only the CFO aggregates (root aggregate and CFO style data aggregates) will be shown.
12. Move the console cable to the target node.
a. If you are running ONTAP 9.6 or later, run the security key-manager onboard sync:
b. Run the
security key-manager onboard sync
prompted.
c. Enter the
security key-manager key query
in the onboard key manager and verify that the
keys.
If the
d. Wait 10 minutes for the key to synchronize across the cluster.
13. Move the console cable to the partner node.
14. Give back the target node using the
15. Check the giveback status, 3 minutes after it reports complete, using the
command.
If giveback is not complete after 20 minutes, contact Customer Support.
16. At the clustershell prompt, enter the
interfaces that are not on their home node and port.
If any interfaces are listed as false, revert those interfaces back to their home port using the
revert command.
17. Move the console cable to the target node and run the
versions.
18. Restore automatic giveback if you disabled it by using the
-auto-giveback true
1120
storage failover giveback -fromnode local
command.
Restored column = anything other than yes/true, contact Customer Support.
storage failover giveback -fromnode local
net int show -is-home false
command.
storage failover show
commands.
command and then enter the passphrase when
command to see a detailed view of all keys stored
column =
Restored
command to check the ONTAP
version -v
storage failover modify -node local
command.
storage failover show
for all authentication
yes/true
command.
storage failover show
command to list the logical
net int