NetApp AFF A200 System Documentation page 897

Ontap systems
Hide thumbs Also See for AFF A200:
Table of Contents

Advertisement

a. Check for unused licenses:
b. If the list looks correct, remove the unused licenses:
Step 2: Restore Storage and Volume Encryption functionality
After replacing the controller module or NVRAM module for a storage system that you
previously configured to use Storage or Volume Encryption, you must perform additional
steps to provide uninterrupted Encryption functionality. You can skip this task on storage
systems that do not have Storage or Volume Encryption enabled.
Step
1. Restore Storage or Volume Encryption functionality by using the appropriate procedure in
Encryption overview with the
Use one of the following procedures, depending on whether you are using onboard or external key
management:
• "Restoring onboard key management encryption keys"
• "Restoring external key management encryption keys"
Step 3: Verify LIFs and registering the serial number
Before returning the replacement node to service, you should verify that the LIFs are on
their home ports, and register the serial number of the replacement node if AutoSupport
is enabled, and reset automatic giveback.
1. Verify that the logical interfaces are reporting to their home server and ports:
-is-home false
If any LIFs are listed as false, revert them to their home ports:
2. Register the system serial number with NetApp Support.
◦ If AutoSupport is enabled, send an AutoSupport message to register the serial number.
◦ If AutoSupport is not enabled, call
3. If automatic giveback was disabled, reenable it:
-giveback true
Step 4: Return the failed part to NetApp
After you replace the part, you can return the failed part to NetApp, as described in the
RMA instructions shipped with the kit. Contact technical support at
463-8277 (North America), 00-800-44-638277 (Europe), or +800-800-80-800
(Asia/Pacific) if you need the RMA number or additional help with the replacement
procedure.
Replace a DIMM - AFF A800
You must replace a DIMM in the controller module when your system registers an
894
license clean-up -unused -simulate
CLI.
NetApp Support
storage failover modify -node local -auto
license clean-up -unused
network interface show
network interface revert
to register the serial number.
NetApp
NetApp
Support, 888-

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AFF A200 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents