NetApp AFF A200 System Documentation page 302

a. Use the
security key-manager key show -detail
the onboard key manager.
b. Use the
security key-manager key show -detail
column = for all authentication keys.
yes
If the Restored
-node Repaired(Target)node
Rerun the
security key-manager key show -detail
for all authentication keys.
yes
12. Connect the console cable to the partner node.
13. Give back the node using the
14. Restore automatic giveback if you disabled it by using the
-auto-giveback true
Option 3: Restore NSE/NVE on systems running ONTAP 9.6 and later
Steps
1. Connect the console cable to the target node.
2. Use the
boot_ontap
3. Check the console output:
If the console
displays...
The login prompt
Waiting for giveback...
4. Move the console cable to the partner node and give back the target node storage using the
failover giveback -fromnode local -only-cfo-aggregates true local
◦ If the command fails because of a failed disk, physically dis-engage the failed disk, but leave the disk in
the slot until a replacement is received.
◦ If the command fails because of an open CIFS sessions, check with customer how to close out CIFS
sessions.
Terminating CIFS can cause loss of data.
◦ If the command fails because the partner "not ready", wait 5 minutes for the NVMEMs to synchronize.
◦ If the command fails because of an NDMP, SnapMirror, or SnapVault process, disable the process. See
the appropriate Documentation Center for more information.
5. Wait 3 minutes and check the failover status with the
6. At the clustershell prompt, enter the
interfaces that are not on their home node and port.
column = anything other than yes, use the
command to restore the Onboard Key Management settings.
storage failover giveback -fromnode local
command.
command at the LOADER prompt to boot the node.
Then...
Go to Step 7.
a. Log into the partner node.
b. Confirm the target node is ready for giveback with the
failover show
net int show -is-home false
to see a detailed view of all keys stored in
command and verify that the
security key-manager setup
command to verify
storage failover modify -node local
command.
storage failover show
Restored
column =
Restored
command.
storage
storage
command.
command.
command to list the logical
299