NetApp AFF A200 System Documentation page 1120

Ontap systems
Hide thumbs Also See for AFF A200:
Table of Contents

Advertisement

If your system has...
No network connection and is in a
MetroCluster IP configuration
4. Ensure that the environmental variables are set as expected:
a. Take the node to the LOADER prompt.
b. Check the environment variable settings with the
c. If an environment variable is not set as expected, modify it with the
variable-name changed-value
d. Save your changes using the
5. The next depends on your system configuration:
◦ If your system has onboard keymanager, NSE or NVE configured, go to
as needed
Then...
a. Press
when prompted to restore the backup configuration.
n
b. Reboot the system when prompted by the system.
c. Wait for the iSCSI storage connections to connect.
You can proceed after you see the following messages:
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected
for the target iSCSI-target (type:
dr_auxiliary, address: ip-address).
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected
for the target iSCSI-target (type:
dr_partner, address: ip-address).
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected
for the target iSCSI-target (type:
dr_auxiliary, address: ip-address).
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected
for the target iSCSI-target (type:
dr_partner, address: ip-address).
d. Select the Update flash from backup config (sync flash) option
from the displayed menu.
If you are prompted to continue with the update, press y.
printenv
command.
command.
savenev
command.
setenv environment-
Restore OKM, NSE, and NVE
1117

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AFF A200 and is the answer not in the manual?

Table of Contents