NetApp AFF A200 System Documentation page 1034

◦ If the Restored
use the
security key-manager restore -address
authentication keys (AKs) and key IDs associated with all nodes from all available key management
servers.
Check the output of the security key-manager query again to ensure that the
and all key managers report in an available state
11. If the Onboard Key Management is enabled:
a. Use the
security key-manager key show -detail
the onboard key manager.
b. Use the
security key-manager key show -detail
column = for all authentication keys.
yes
If the
Restored
-node Repaired(Target)node
Rerun the
security key-manager key show -detail
for all authentication keys.
yes
12. Connect the console cable to the partner node.
13. Give back the node using the
14. Restore automatic giveback if you disabled it by using the
-auto-giveback true
Option 3: Restore NSE/NVE on systems running ONTAP 9.6 and later
Steps
1. Connect the console cable to the target node.
2. Use the
boot_ontap
3. Check the console output:
If the console
displays...
The login prompt
Waiting for giveback...
4. Move the console cable to the partner node and give back the target node storage using the
failover giveback -fromnode local -only-cfo-aggregates true local
◦ If the command fails because of a failed disk, physically dis-engage the failed disk, but leave the disk in
the slot until a replacement is received.
◦ If the command fails because of an open CIFS sessions, check with customer how to close out CIFS
sessions.
column = anything other than yes, and/or one or more key managers is not available,
column = anything other than yes, use the
command to restore the Onboard Key Management settings.
storage failover giveback -fromnode local
command.
command at the LOADER prompt to boot the node.
Then...
Go to Step 7.
a. Log into the partner node.
b. Confirm the target node is ready for giveback with the
failover show
command to retrieve and restore all
to see a detailed view of all keys stored in
command and verify that the
security key-manager setup
command to verify
storage failover modify -node local
command.
column =
Restored yes
Restored
column =
Restored
command.
storage
storage
command.
1031