Wireless Group Setting; Other Applications; Sync Cable Triggering - Godox V1 C Instruction Manual

Wireless Group Setting

Press function key
1.
Turn control dial to set group . Press
2.
•
•
•
•
•

Other Applications

Sync Cable Triggering

Flash is equipped with a standard 3.5mm Jack socket. Insert corresponding cable plug
into the socket (other end must be connected to the cameras flash sync port). Flash
will be fired synchronously with the camera shutter.
•
•
1 <GR>.
Use <TEST> button on your Godox X trigger to check if communication
between all devices is set properly. Make sure that the flash and
transmitter are set to the same radio channel, otherwise the test flash
will not be triggered.
If the flash is triggered without pressing <TEST> or cameras shutter
button, change the channel. Devices such as WIFI routers or telephones
can interfere with Godox X radio system.
If the distance between the transmitter and the flash is small, select the
short-range mode (e.g. in Godox X2 it is possible to select C.Fn-DIST 0-
30m). This will deliver stable radio connection but at the cost of shorter
range.
Always keep your Godox X trigger batteries fully charged to ensure max
range and stable communication between devices.
Using light modifiers does not interfere with the Automatic TTL Flash
Metering.
Sync cable is not supplied.
You can use flash sync port to connect radio triggers other than Godox
X. TTL, HSS sync and remote power adjustment is not possible in that
case.
<SET/OK> to confirm.
30