TTL: Fully Automatic Wireless Flash Shooting
TTL Wireless Flash with a Single Slave Unit
1. Master Unit Setting
Attach a V1C camera flash on the camera
•
and set it as the master unit.
•
X1T-C can also be used as master unit. X1T-C
can control V1C 's ZOOM
value when the ZOOM is adjusted to auto
•
(A) mode.
2. Slave Unit Setting
•
Set the other camera flash as the wireless
slave Unit.
3. Check the communication channel.
If the master unit and slave unit(s) are set to
•
a different channel, set them to the same
channel.
4. Position the camera and flashes.
Position the camera and flashes as the
•
picture shows.
5. Set the master unit's flash mode to <TTL>.
•
Set the master unit's flash mode to <ETTL>.
•
For shooting, <ETTL> will automatically be
set for the slave unit.
Set the master unit flash firing as ON to fire
•
a flash.
6. Check that the flash is ready.
•
Check that the master flash ready indicator
is lightened.
When the slave flash ready indicator is
•
ready, the Afassist beam lighting area will
blinks at 1 second intervals.
7. Check the flash operation.
Press the master unit's
•
Test Button.
•
Then, the slave unit will fire. If not, adjust
•
the slave unit's angle toward the master unit
and distance from the master unit.
27