Module Installation And Removal; Figure 5-1. Jetson Orin Nx Module Installed In Sodimm Connector; Figure 5-2. Module To Connector Assembly Diagram - Nvidia Jetson Orin NX Design Manual

Figure 5-1. Jetson Orin NX Module Installed in SODIMM Connector
Mounting Screws
5.3

Module Installation and Removal

To install the Jetson Orin NX module correctly, follow the sequence and mounting hardware
instructions:
Here are some suggested assembly guidelines.
Assemble any required thermal solution on the module.
1.
Install the module
2.
Start with baseboard that has suitable standoff to match SODIMM connector height.
a).
Insert module fully at an angle of 25-35 degree into the SODIMM connector.
b).
Arc down the module board until the SODIMM connector latch engages.
c).
Secure the module to the baseboard with screws into the standoff or spacer (shown in
d).
Figure 5-2).
Figure 5-2. Module to Connector Assembly Diagram
To remove the module correctly, follow the installation sequence in reverse.
PRELIMINARY INFORMATION
NVIDIA Jetson Orin NX
Standoffs
Modular Connector
SO-DIMM
Connector
Jetson Orin
NX Module
(Envelop view)
Mounting Screw
Standoff
DG-10931-001_v0.1 | 12