Front Panel Features - Extron electronics DTP HD DA 4K Series User Manual

Dtp hdmi distribution amplifier
Hide thumbs Also See for DTP HD DA 4K Series:
Table of Contents

Advertisement

I
J
K

Front Panel Features

CONFIG
A B
CONFIG
A B
Figure 5.
A
B
C
D
E
F
Reset button and LED (see
default settings, press and hold this Reset button for approximately 9 seconds. The
reset LED flashes green 3 times, once every 3 seconds. After the third flash, release the
button and quickly press it once more to complete the reset. The LED flashes green 3
times indicating that the default settings have been restored.
LAN (Ethernet) cport — Use an RJ-45 cable to connect this jack to a LAN (Ethernet)
for control of the device (see
on page 8 for wiring details).
Remote RS‑232 port — To control the unit, connect an RS-232 device to this 3-pole,
3.5 mm captive screw connector and configure it as follows: 9600 baud rate, 8 data
bits,1 stop bit, no parity (see
details).
DTP HD DA 4K Series Front Panel
Power status LED — Lights green when power is applied to the unit.
USB Config port — Used for firmware updates, SIS configuration, and software
control. This port can be used as an alternative to the rear panel Remote RS-232
captive screw connector (see figure 3,
NOTES:
Neither port has precedence and commands from either port are handled in the
order they are received.
Extron recommends that the USB port is used for temporary connections. If a
permanent connection is required, the RS-232 port or an IP connection should
be used.
Input Signal LED — Lights green when a signal is detected on the HDMI input.
Input HDCP LED — Lights green when HDCP presence is detected on the HDMI input.
Output Signal LEDs — Light green when a signal is detected on the HDMI outputs.
Output HDCP LEDs — Light green when HDCP presence is detected on the HDMI
outputs.
Extron DTP HD DA 4K Series • Installation and Operation
figure 3
on page 4)— To reset the unit to factory
TP Cable Termination for Ethernet Communication
Remote RS‑232 Control Wiring
C
INPUT
SIGNAL
HDCP
D
C
INPUT
SIGNAL
HDCP
D
on page 4).
K
on page 8 for wiring
E
OUTPUTS
LOOP
1
2
3
4
THRU
DTP HD DA4 Series
DTP DISTRIBUTION AMPLIFIER
F
E
OUTPUTS
LOOP
1
2
3
4
5
6
7
8
THRU
DTP HD DA8 Series
DTP DISTRIBUTION AMPLIFIER
F
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dtp hd da8 4k series

Table of Contents