Table of Contents
Advertisement
Front Panel Features
This section describes the front panel features of the DA2 HD 8K L distribution amplifier:
R
e
A A A
B B B
Figure 5.
Front Panel Features
Power status LED — Lights when power is applied to the unit.
A
Reset button — Press the reset button to initiate one of four rest modes (see Reset).
B
USB Config port — Connect a USB‑C cable to a PC to configure or monitor the DA via SIS commands and
C
PCS.
NOTE: Extron recommends using the USB port for temporary connections. If a permanent connection is
required, the LAN port should be used (see the
Input LEDs —
D
•
Signal LED — Lights when a TMDS signal is detected on the HDMI input. If the source requires HDCP
encryption, this LED may light only when HDCP is authenticated.
•
HDCP LED — Lights when the source requires HDCP encryption and it has been authenticated with the
HDMI input.
Outputs —
E
•
Signal LEDs — Light when hot plug detect is detected from the corresponding sink device. Each output
signal has its own signal LED.
•
HDCP LEDs — Light when HDCP is authenticated between the DA output and the corresponding sink
device. This happens when the source device requires HDCP encryption and it has already been
authenticated on the HDMI input.
•
The LEDs do not light if the source does not require HDCP encryption or if the sink is not HDCP
compliant.
•
Each output signal has its own HDCP LED.
Reset
The front panel Reset button initiates four levels of resets. Use a pointed stylus, ballpoint pen, or small
screwdriver to access the recessed button.
Reset Modes
See the
ATTENTION:
•
Review the reset modes carefully. Some reset modes delete all user loaded content and revert the
device to default configuration.
•
Analysez minutieusement les différents modes de réinitialisation. Certains modes de réinitialisation
suppriment l'intégralité du contenu chargé de l'utilisateur et remettent l'appareil au mode de
configuration par défaut.
INPUT
SIGNAL
CONFIG
HDCP
D D D
C C C
on page 10 for a summary of the resets.
OUTPUTS
1
2
DA2 HD 8K L
E E E
Rear Panel Connections
Power Status LED
A
Reset button
B
USB Config port
C
Input LEDs
D
Output LEDs
E
on page 5) .
DA2 HD 8K L • Installation
9
Advertisement
Table of Contents
