Front Panel Features - Extron electronics DTP HD DA 4K Series User Manual

Dtp hdmi distribution amplifiers
Hide thumbs Also See for DTP HD DA 4K Series:
Table of Contents

Advertisement

Front Panel Features

CONFIG
A B
CONFIG
A B
Reduced air flow — Installation of the equipment in a rack should be such that the
amount of air flow required for safe operation of the equipment is not compromised.
Mechanical loading — Mounting of the equipment in the rack should be such that a
hazardous condition is not achieved due to uneven mechanical loading.
Circuit overloading — Consideration should be given to the connection of the
equipment to the supply circuit and the effect that overloading of the circuits might have
on overcurrent protection and supply wiring. Appropriate consideration of equipment
nameplate ratings should be used when addressing this concern.
Reliable Earthing — Reliable earthing of rack-mounted equipment should be
maintained. Particular attention should be given to supply a connection other than a
direct connection to a branch circuit, such as by using a power strip.
Figure 3.
DTP HD DA 4K Series Front Panel
Power status LED — Lights green when power is applied to the unit.
A
USB Config port — Used for firmware updates, SIS configuration, and software
B
control. This port can be used as an alternative to the rear panel Remote RS-232
captive screw connector (See Rear Panel Features on the following page).
NOTES:
Neither port has precedence and commands from either port are handled in
the order they are received.
Extron recommends that the USB port is used for temporary connections.
If a permanent connection is required, the RS-232 port or an IP connection
should be used.
Input Signal LED — Lights green when a signal is detected on the HDMI input.
C
Input HDCP LED — Lights green when HDCP presence is detected on the HDMI
D
input.
Output Signal LEDs — Light green when a signal is detected on the HDMI outputs.
E
Output HDCP LEDs — Light green when HDCP presence is detected on the HDMI
F
outputs.
Extron DTP HD DA 4K Series • Installation and Operation
C
E
OUTPUTS
INPUT
SIGNAL
LOOP
1
2
3
4
THRU
HDCP
DTP DISTRIBUTION AMPLIFIER
D
F
C
E
OUTPUTS
INPUT
SIGNAL
LOOP
1
2
3
4
5
6
7
THRU
HDCP
DTP DISTRIBUTION AMPLIFIER
D
F
DTP HD DA4 Series
8
DTP HD DA8 Series
5

Advertisement

Table of Contents
loading

Table of Contents