Table of Contents
Advertisement
number, and 60-xxxx-01 is the catalog part number.
This is followed by a Password prompt if a password has been set.
NOTE: The factory configured passwords for all accounts on this device have been set
Using the Command and Response Table
The
are used throughout the table to represent variables in the command response fields.
Command and response examples are shown throughout the table. The ASCII to HEX
conversion table (see figure 9) is for use with the command and response table.
Figure 9.
NOTE: For commands and examples of computer or device responses used in this
Symbol Definitions
] = CR/LF (carriage return with line feed)
| or } = Soft carriage return (no line feed)
•
E or W = Escape key
NOTE: If unit does not support or recognize the entered commands, nothing happens
X!
X@
X#
X$
X%
X^
to the device serial number. Passwords are case sensitive.
Command and Response Table for SIS Commands
ASCII to Hex Conversion Table
guide, the character "0" is the number zero and "O" is the capital letter "o".
= Space
and no response is issued.
Output selection
=
=
Status
Video color bit depth
=
=
EDID memory location
=
EDID data as 256
bytes of hex data (text
representation)
=
Native resolution and refresh
rate (translated from hex)
Extron DTP HD DA 4K Series • SIS Configuration and Control
starts on page 15. Symbols
0-4 or loop out to 4 (DTP HD DA4 models)
0-8 or loop out to 8 (DTP HD DA8 models)
0 = disabled/off/undetected
1 = enabled/on/detected
0 = Auto (based on EDID of sink, default)
1 = Force 8-bit
See the
DTP HD DA 4K Series EDID Memory
Locations
on page 14.
Example: 1600x1200 @ 60 Hz
11
Advertisement
Table of Contents
