Table of Contents
Advertisement
X5*
=
Baud rate
X5(
=
Parity
X6)
=
Data bits
Stop bits
X6!
=
X6$
=
Port timeout intervals
Start point for UART ports
X6%
=
Video mute
X6^
=
View HDCP Notification
X6&
=
Error Responses
E01 — Invalid input channel number
•
E10 — Invalid command
•
E13 — Invalid value
•
E24 — Privilege violation
•
•
E28 — Bad filename/File not found
EDID
User Assigned Mode
In user assigned mode, the user can select from 55 factory loaded EDID files, each
categorized by rate type (PC or HDTV), video format (DVI or HDMI), audio type (2-Ch or
Multi-Ch), and native resolution. The unit retains this setting after a power cycle.
Additionally, two user-loaded slots are available to save the EDID of any connected display.
EDID saved to these slots are retained after a power cycle. Upon a factory reset, these EDID
revert to the factory default (720p @ 60 Hz, 2-Ch audio).
A table showing the factory loaded EDID options is shown on the following page. The EDID
memory location is labelled X$ for consistency with the value in the SIS commands.
Default = 9600
Port 1 is fixed at 9600
Odd, Even, None (default), Mark, Space (only the
first letter is required)
7-8
(8 = default)
1, 2
(1 = default)
1-65000
(1 = 10 seconds; default = 30 - 300 seconds = 5
minutes, in 10-second increments)
1999 = default
0 = Video mute disabled
1 = Video mute
2 = Video and sync mute
0 = Green screen (default); 1 = Black screen
Extron DTP HD DA 4K Series • SIS Configuration and Control
13
Advertisement
Table of Contents
