Table of Contents
Advertisement
Connection Details
For connectors that require additional wiring details or recommendations, see the following
sections pertaining to the type or connection.
TP Cable Recommendations and Termination for DTP Communication
Use the following configuration for twisted pair cables used for DTP communication.
Side
Pair Wires
Figure 6.
Supported cables
The distribution amplifiers are compatible with shielded twisted pair cable (F/UTP, SF/UTP,
and S/FTP).
ATTENTION:
Cable recommendations
Extron recommends using the following practices to achieve full transmission distances up
to 330 feet (100 meters) and reduce transmission errors.
•
•
•
•
Pins:
RJ-45
1 2 3 4 5 6 7 8
Connector
TIA/EIA T
568 B
Pin
Wire color
1
White-orange
Orange
2
3
White-green
4
Blue
5
White-blue
6
Green
Insert
7
White-brown
Twisted
8
Brown
RJ‑45 Pin Assignment for DTP Communication
•
Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201
cable to link the device with DTP transmitters or receivers.
•
N'utilisez pas le câble AV Skew-Free UTP version améliorée UTP23SF d'Extron ou
le câble STP201 pour relier le appareil avec les émetteurs ou les récepteurs DTP.
Use the following Extron XTP DTP 24 STP cables and DTP 24 connectors for the best
performance:
•
XTP DTP 24/1000
•
XTP DTP 24P/1000
•
XTP DTP 24 Plug
If not using XTP DTP 24 cable, at a minimum, Extron recommends 24 AWG, solid
conductor, STP cable with a minimum bandwidth of 400 MHz.
Terminate cables with shielded connectors to the TIA/EIA-T568B standard.
Limit the use of more than two pass-through points, which may include patch points,
punch down connectors, couplers, and power injectors. If these pass-through points
are required, use shielded couplers and punch down connectors.
Non-Plenum 1000 feet (305 meters) spool
Plenum 1000 feet (305 meters) spool
Package of 10
Extron DTP HD DA 4K Series • Installation and Operation
7
Advertisement
Table of Contents
