Advertisement
Front Panel Features
A
B C
CONFIG
R
e
Figure 2.
Front Panel Features
Power LED — This LED lights green when the unit is powered up, and amber when it is in power save mode.
A
Reset button — Pressing this inset button resets the device to default settings (see the PVCA 452 User Guide for the
B
various reset modes).
Configuration port — Connect a computer to this USB-C port (cable not supplied) for device configuration, control, and
C
firmware upgrades.
Page Sensor LED — Lights yellow when paging system broadcasts are detected.
D
NOTE:
For page sensor installation and operation details, see the PVCA 452 User Guide available at www.extron.com.
eBUS status LEDs — These LEDs indicate the following eBUS port states:
E
•
Link (L) LED — Lights green when eBUS devices are discovered.
•
Busy (B) LED — Blinks yellow when eBUS device firmware sync is in progress.
•
Error (E) LED — Blinks red when BUS ID conflicts are detected.
•
Limit LED — Lights yellow if eBUS power consumption is within limit load range.
•
Over LED — Lights red if eBUS power consumption is greater than or equal to the load limit.
COM LED — Lights green when the corresponding serial port is transmitting (Tx) or receiving (Rx) data.
F
IR/S LED — Lights green when a signal is transmitting on the rear panel IR/S port.
G
Digital I/O LEDs —
H
•
When in digital input mode: LED is on when port input is above the threshold.
•
When in digital output mode: LED is on when the port is enabled.
CEC LED (future use)
I
LAN LEDs —
J
•
1000 LED — Indicates Single 1000Base-T network connection
•
LINK LED — Indicates link status
•
ACT LED — Indicates network activity
PVCA 452 Configuration
The PVCA 452 amplifier can be controlled and configured using Extron Product Configuration Software (PCS),
Global Configurator Pro/Plus (GCP), and ToolBelt via a host computer. Firmware updates can also be made using PCS.
•
PCS is used for setup and adjustment of PVCA 452 A/V functions. For information on accessing PCS, see the PVCA 452 User
Guide (available at www.extron.com). For configuration details, see the embeded help file in PCS.
•
For Global Configurator Pro/Plus, see Configuring the PVCA 452 using Global Configurator below.
NOTE:
The factory configured password for this device has been set to the device serial number. Passwords are case sensitive.
Performing a reset to factory defaults sets the password to extron (see the PVCA 452 User Guide for reset instructions).
Configuring the PVCA 452 using Global Configurator
NOTE:
The following are the most basic steps, outlined in the recommended order. For detailed instructions, see the Global
Configurator Help File. The help file includes an introduction to the software, and instructions on starting a project.
1.
Connect the host computer and the PVCA 452 to the same Ethernet subnetwork (see
2.
Start Global Configurator Pro/Plus (GCP) and open the Toolbelt feature (or use the stand-alone Toolbelt program).
5
D
E
F G H I
F
PAGE
eBUS
COM
IR/S
I/O
SENSOR
L
LIMIT
B
Tx
1
Rx
2
E
OVER
LAN port
on page 4).
J
CEC
1000
LINK
ACT
PVCA 452
Advertisement
