Connecting A Bluetooth Scanner (Rs507) Directly To The Vc70 (Spp Profile); Connecting A Bluetooth Scanner (Ds3578/Ls3578) Directly To The Vc70 (Spp Profile) - Motorola VC70N0 Product Reference Manual

2 - 38 VC70 Vehicle Computer Product Reference Guide

Connecting a Bluetooth Scanner (RS507) Directly to the VC70 (SPP Profile)

NOTE Refer to the scanner Product Reference Guide for information on configuring the scanner.
To connect a Bluetooth scanner to the VC70:
Ensure that the scanner battery is fully changed.
1.
Scan a SPP Profile barcode to configure the scanner to Bluetooth SPP profile mode before the pairing.
2.
SPP Profile Bar Code
Figure 2-70
NOTE Perform a cold boot by removing and re-installing the battery onto the RS507.
To pair the scanner with your VC70, scan the pair label barcode in the upper right side of the VC70.The
3.
scanner beeps indicating that it is successfully connected to the VC70.
Verify that the scanner is connected properly. See
4.
When completing scanning, scan the unpair label barcode in the upper left side of the VC70. This will
5.
disconnect your scanner from the VC70.

Connecting a Bluetooth Scanner (DS3578/LS3578) Directly to the VC70 (SPP Profile)

NOTE Refer to the scanner Product Reference Guide for information on configuring the scanner.
To connect a Bluetooth scanner to the VC70:
Ensure that the scanner battery is fully changed.
1.
Scan the
2. Set All Defaults
Set All Defaults Bar Code
Figure 2-71
NOTE The above allows the scanner to reset from any previous configuration to the default configuration.
Verifying the Scanner is Working Properly on page
bar code.
2-42.