Cradle Host Bar Code
Figure 2-67
Scan Write to Custom Defaults barcode.
4.
Custom Default Bar Code
Figure 2-68
To pair the scanner with your VC70, scan the pair label barcode in the upper right side of the VC70.The
5.
scanner beeps indicating that it is successfully connected to the VC70.
Verify that the scanner is connected properly. See
6.
When completing scanning, scan the unpair label barcode in the upper left side of the VC70. This will
7.
disconnect your scanner from the VC70.
Connecting a Bluetooth Scanner (RS507) Directly to the VC70 (Scan Profile)
NOTE Refer to the scanner Product Reference Guide for information on configuring the scanner.
To connect a Bluetooth scanner to the VC70:
Ensure that the scanner battery is fully changed.
1.
Scan a Scan Profile barcode to configure the scanner to Bluetooth SCAN API mode before the pairing.
2.
Scan Profile Bar Code
Figure 2-69
NOTE Perform a cold boot by removing and re-installing the battery onto the RS507.
To pair the scanner with your VC70, scan the pair label barcode in the upper right side of the VC70.The
3.
scanner beeps indicating that it is successfully connected to the VC70.
Verify that the scanner is connected properly. See
4.
When completing scanning, scan the unpair label barcode in the upper left side of the VC70. This will
5.
disconnect your scanner from the VC70.
Verifying the Scanner is Working Properly on page
Verifying the Scanner is Working Properly on page
Installation 2 - 37
2-42.
2-42.