10Base5 Connection - Toshiba TOSDIC-CIE DS Installation And Wiring Manual

4. Wiring of DPCS

10BASE5 connection

This section describes how to connect DPCS to a transceiver. First, check that the "MODE"
switch on the front panel of the DPCS-Ethernet connection card VETHX1 is in the "E-5" side.
Set to the E-5 side
MODE
E-T E-5
V E T H X 1
Figure4.6 Mode switch setting
In this case, CN4 is used as the Bus A of the control LAN and CN5 is used as the Bus B.
95