Configuring With Cpistatus Table; Data Logger Programming - Campbell TEMP 120 Product Manual

7. Select the port labelled TEMP 120.
8. Click OK.
9. Click Connect then OK to avoid conflicts.
10. Set the Device Name (optional) and the CPI Address.
a. Device Name is a user-editable field to set a unique name to the TEMP 120. The
default name is TEMP 120.
b. CPI Address specifies the address of the TEMP 120. Each GRANITE Measurement
Module connected to the same data logger must have a unique address. By default,
the TEMP 120 uses a CPI address of 1. Allowable addresses are 1 through 120.
11. Click Apply to save your changes.

9.3.4 Configuring with CPIStatus table

When a GRANITE Measurement Module is used in a program, the data logger adds a CPIStatus
table to display current CPI information. View the CPIStatus table in the LoggerNet Connect
screen, or Device Configuration Utility Data Monitor tab. Information about each module
included in the data logger program or connected to the CPI bus appears in the CPIStatus table
within the ModuleInfo() array. Information is shown in the following order:
GRANITE Measurement Module Type, Serial Number, Device Name, CPI Address, Activity,
CDM OS Version
Within the ModuleInfo() array index string, the Device Name and CPI Address fields can be
edited. This provides a way to rename and readdress a TEMP 120 through Campbell Scientific
software without editing the CRBasic program or connecting directly to the USB port.
See CPIStatus table (p. 24) for additional information.

9.4 Data logger programming

Short Cut is the best source for up-to-date data logger programming code. Programming code
is needed when:
Creating a program for a new data logger installation
l
Adding sensors to an existing data logger program
l
If your data acquisition requirements are simple, you can likely create and maintain a data logger
program exclusively with Short Cut. If your data acquisition needs are more complex, the files that
Short Cut creates are a great source for programming code to start a new program or add to an
existing custom program.
TEMP 120 15