Status Led; Cpi Port Leds - Campbell TEMP 120 Product Manual

Table 12-1: CPIStatus activity
Response
The module is connected to the CPI bus and is making measurements according
Active
to the data logger program.
Offline The module was present after startup but is no longer responding.
The module is or was connected and powered but is not included in the data
Unused
logger program.
Wait Config The module has not yet responded to a data logger's attempts to configure it.
The module could not be configured. A configuration error message is appended
Config Fail
to this response.

12.2 Status LED

The Status LED indicates the current operation of the TEMP 120, as shown in the following table..
Table 12-2: COMM Status LED Activity
Green Flashing
Orange Flashing
Single-Flash Device has been configured but is not receiving sync signals
Double-
Red
Flash
Solid

12.3 CPI port LEDs

Green and Orange LEDs on the CPI bus indicate the current operation of the CPI bus as shown in
the following table.
Table 12-3: CPI port LED activity
Green Flashing Frame sync
Flash
Orange
Solid
Module has been configured by data logger and is receiving sync
signals
Device has not been configured by data logger
Device has encountered a scan timeout
Error
CPI activity
CPI bus fault
Meaning
TEMP 120 25