Table of Contents
Advertisement
Configure the TEMP 120 using one of four methods: through SURVEYOR, the
program instruction, Device Configuration Utility software, or the CPIStatus table.
9.3.1 Configuring with SURVEYOR
Modules are automatically configured when connected to SURVEYOR. SURVEYOR sets the
module CPI address to 1 and uses the device type and serial number to generate and assign a
device name such as 'TEMP120-1234'.
For more information see
9.3.2 Configuring with the CPIAddModule() instruction
To configure a TEMP 120 within a program, use the
instruction is used for each device. The
by other means, such as Device Configuration Utility or the CPIStatus table.
CPIAddModule(CDMType, CDMSerialNo, CDMDeviceName, CPIAddress)
The data logger creates an internal list of CPI modules from each
Modules added to the CPI bus will be checked against this list and reconfigured accordingly. See
a programming example:
28).
NOTE:
The
CPIAddModule()
Configuration Utility or the CPIStatus table.
9.3.3 Configuring with Device Configuration Utility
Install the device driver before connecting the TEMP 120 to a computer. This is optional for
Windows 10, or later, operating systems.
1. Open Device Configuration Utility.
2. Under Device Type, select GRANITE > TEMP 120.
3. Carefully review the Connect Instructions text provided on the right.
4. With the USB device driver installation complete, connect the supplied USB cable between
the USB port on your computer and the USB port on the TEMP 120.
5. Apply 9.6 to 32 VDC to the power terminals on the device.
6. Click the browse button next to Communication Port.
Measurement quickstart using SURVEYOR
CPIAddModule()
Configuring GRANITE Measurement Module with CPIAddModule()
instruction overrides changes made through SURVEYOR, Device
(p. 2)
CPIAddModule()
instruction overrides settings entered
CPIAddModule()
CPIAddModule()
instruction. A separate
instruction.
TEMP 120
(p.
14
Advertisement
Table of Contents
