Install Driver For Computer Connection; Operating Systems; Configuring Temp 120 - Campbell TEMP 120 Product Manual

9.3 Configuring TEMP 120
9.4 Data logger programming
9.5 Data logger connection
9.6 Connecting multiple GRANITE Measurement Modules
9.7 Power connection
9.8 Earth ground connection
9.9 Mounting in an enclosure

9.1 Install driver for computer connection

SURVEYOR automatically installs the required drivers.
SURVEYOR (p. 2). When SURVEYOR is not used, the device driver must be installed before
connecting to the TEMP 120 via USB for the first time.
To install the device driver using the Device Configuration Utility, select GRANITE > TEMP 120.
Click the Install the USB driver link and follow the prompts.
TIP:
Driver installation is optional for computers running Windows 10 and later.

9.2 Operating systems

Campbell Scientific posts operating system (OS) updates at
when they become available. Before deploying instruments, check OS versions and update as
needed to the most recent version. Use the Device Configuration Utility and follow the
procedures on the Send OS tab.
NOTE:
For best performance, use the most recent OS for each device.

9.3 Configuring TEMP 120

The TEMP 120 arrives ready to be connected to a system. Device configuration is only required
when multiple GRANITE Measurement Modules are connected to a single data logger. Each
module must have a unique CPI address. Set a unique device name for further distinction
between GRANITE Measurement Modules.
See: Measurement quickstart using
www.campbellsci.eu/downloads
13
15
17
17
19
19
19
TEMP 120 13