Checks To Be Run At The Start Of Each Working Day; Lubricating Oil Level Check; Checking That The Flex Hoses Are In Good Condition; Controlli Prima Dell'inizio Di Ogni Giornata Lavorativa - Coltri Compressors PRIME LINE MARK 3 TPS MCH-13/ET Use And Maintenance Manual

Table of Contents

Advertisement

ENGLISH
6.2
CHECKS TO BE RUN AT THE START OF EACH
WORKING DAY
Inspect the exterior of the compressor (couplings, pipes, pneumatic
components etc.) and check for any oil leaks. Replace parts where necessary
or contact AEROTECNICA COLTRI.
6.2.1

Lubricating oil level check

Check that the lubricating oil level (a) is within acceptable limits (MIN.-
MAX.).
Note that an excessive quantity of oil can cause infiltrations in the cylinders
and leave deposits on the valves while too low a level prevents proper
lubrication and could cause engine seizure.
If the oil level is not within the minimum and maximum limits top up or
drain as described in section "7.10 Changing the lubricating oil".
a
6.2.2
Checking that the refill flex hoses are in good condition
Inspect the refill hoses and make sure there are no cuts, holes, abrasions,
leaks etc. If necessary replace with new hoses.
32 - 60
MARK 3 TPS
ITALIANO
6.2
CONTROLLI PRIMA DELL'INIZIO DI OGNI
GIORNATA LAVORATIVA
Effettuare un'ispezione esterna del compressore (giunture, tubi, componenti
pneumatici, ecc.) e controllare se si notano perdite d'olio. Nel caso sostituire
la parte difettosa o contattare AEROTECNICA COLTRI.
6.2.1

Verifica livello olio lubrificante

Controllare che il livello dell'olio lubrificante (a) sia entro i limiti previsti
(MIN.- MAX.).
Si ricorda che un eccesso di olio può causare infiltrazioni nei cilindri e
deposito sulle valvole mentre un livello troppo basso impedisce una
corretta lubrificazione con la possibilità di grippaggio dei cilindri.
Nel caso il livello dell'olio non risulti entro i limiti previsti procedere alle fasi
di rabbocco o scarico seguendo le operazioni riportate nel paragrafo "7.10
Sostituzione olio lubrificante".
6.2.2
Controllo dell'integrità delle fruste di ricarica
Effettuare un'ispezione delle fruste di ricarica e controllare che non
presentino tagli, fori, abrasioni, perdite, ecc. Nel caso sostituire con fruste
nuove.
a
MU-MARK3TPS-0920

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PRIME LINE MARK 3 TPS MCH-13/ET and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents