Parts Replacement Procedures - Mitsubishi Electric e Series Service Handbook

[ IX Troubleshooting ]

[5] Parts Replacement Procedures

WARNING
Do not use refrigerant other than the type indicated in
the manuals provided with the unit and on the
nameplate.
• Doing so may cause the unit or pipes to burst, or result in
explosion or fire during use, during repair, or at the time of
disposal of the unit.
• It may also be in violation of applicable laws.
• MITSUBISHI ELECTRIC CORPORATION cannot be held
responsible for malfunctions or accidents resulting from the
use of the wrong type of refrigerant.
Thermistor (TH21)
Thermistor
(TH26)
Four way
valve
<EAHV only>
HWE1417B
Linear expansion valve
Scroll compressor (SUB)
Water-side
heat exchanger assy
Pressure
sensor LP
Pressure
sensor HP
High
pressure
switch
Strainer Belt heater
Rubber mount
Oil separator Thermistor
(TH27)
Tank assy
<EAHV only>
Check valve
Thermistor
(TH10)
Accumulator
Thermistor (TH5)
Water-side
heat exchanger assy
Check joint Check joint
Strainer
Strainer Thermistor
(TH6)
Thermistor Thermistor
(TH7)
(TH1)
Thermistor
(TH2)
Heat exchanger
Thermistor
Air purge valve
Housing joint (40A)
<Standard piping type>
- 146 -
Linear expansion valve
Thermistor (TH11)
Scroll compressor
(MAIN)
Pressure
sensor LP
Pressure
sensor HP
High
pressure
switch
Strainer Belt heater
Oil separator
Rubber mount
Four way valve
<EAHV only>
(TH3)
Thermistor (TH25)
GB