[ II Restrictions ]
2. Switch on the power to the unit.
Check for loose or incorrect wiring, and then switch on the power to all modules.
When the power is switched on, the following codes will appear on the LED:
• [EEEE] will appear on LED1 in the MAIN circuit board.
• [9999] will appear on LED1 in the SUB circuit board.
Main module (SUB circuit)
Sub module (SUB circuits)
10's digit (5) 1's digit (1)
Within 50 seconds after the power is switched on, the following codes will appear on the LED:
• [****] will appear on LED1 in the MAIN circuit board.
• [0000]→[****] will appear on LED1 in the SUB circuit board.
****
0000
EACV-P900YA
0001
EAHV-P900YA
0002
EAHV-P900YA-H
Then, the setting item "SW3-3" (page 81) will appear on the LED.
ON
1
2
3
4
5
6
7
8
9 10
HWE1417B
(0)
[9999]
Model
The figure at left shows that the switches 1 through 5 are set to ON and 6 through 10 are set to OFF.
Main module (MAIN circuit)
Sub module (MAIN circuits)
10's digit (0) 1's digit (1)
- 25 -
(0)
[EEEE]
GB