VETRON 5400 Instruction Manual page 38

05. PROGRAMMING
04. PROGRAM PARAMETER
-1-14
ADVICE:
A seam program can be created with the following parameters. When a function is deactivated the according parameter
will not be displayed. To select a progam parameter you have to turn the JOG KEY and push it when the desired parameter
appears. It will now flash. Now you can select the desired parameter setting by turning the JOG KEY. The new setting will be
stored by pushing the JOG KEY again.
NR. PARAMETER
» STITCH LENGTH IN THE SEAM
010 Stitch length 1
011 Stitch length 2
Button
4
018
Stitch length trigger function
NR. PARAMETER
» FOOT STROKE
020 Foot stroke 1
021 Foot stroke 2
07/2020
36
VETRON 5400 - CYLINDER ARM MACHINE - INSTRUCTION BOOK
DESCRIPTION
Main stitch length in mm in the seam. The stitch length can also be entered in
the negative range. The seam will be done in reverse.
Second stitch length, which can be selected by pushing button
018). The stitch length can also be entered in the negative range. The seam will
be done in reverse.
Select function with button
OFF Without function
SWITCH Stitch length will change to 2
it. When button is released 1
TOGGLE Stitch length will change when button is pressed. When it is
pressed a second time, it will change back to 1
DESCRIPTION
Stroke in mm during normal sewing. The value must be set depending on
the thickness and texture of the material to achieve a correct material feed.
2 nd stroke in mm. Can be switched on when reaching thick joints in the seam.
Switching over can be done with key
It can also be done with a knee lever (optional) or with the automatic switch
parameter 027.
1
4
2
3
.
4
stitch length as long as you hold
nd
stitch length is back.
st
or the electronic handwheel
3
(parameter
4
stitch length.
st
.
1