Table of Contents
Advertisement
A.
Unpackage the Handlebars
1. Open carton, remove and unpackage all components.
2. Check to be sure all components are present. The carton contains
1 Left Handlebar(12), 1 Right Handlebar(13), and a hardware kit.
B.
Remove the Original Handlebar End Caps (2) from the treadmill
1. Remove the two screws (27), located under the handlebar, holding the
end cap on.
2. Use a small screw driver to remove the end caps (28).
3. The treadmill will need to be raised in the back or laid on its side in
order to attach the medical handlebars. If raising the back end up, it
is good to have the back end at least one foot off the ground.
View From
Beneath
28
27
Assembling Your Treadmill
Note:
The assembly
instructions are
written as if the
treadmill is raised
in the back.
25
Advertisement
Table of Contents
