Table of Contents
Advertisement
Assembling Your Treadmill
Step 4: Handlebar Attachment
A.
Hold the handlebar set (7) above the upright posts (4 and 5). Feed the cable
(17) from the right support post (5) through the square hole on the right
side of the handlebar set.
B.
Place the handlebar set (7) onto the support post (4 and 5). Be careful not
to pinch the cable (17) on the right side.
C.
Align the bolt holes in the handlebar set (7) to the holes in the upper end of
the support posts (4 and 5).
D.
Install the four bolts (10) from the hardware bag. Do not tighten the bolts
until all four bolts have been installed.
E.
Tighten the three bolts (15) on the bottom of each support post
installed in steps 3-B and 3-D.
F.
Connect the cable (17) from the support post to the cable (19) inside of the
handlebar set.
10
4
20
19
17
10
17
5
M8 x 55L Bolt
(x4)
7
5mm Allen
Wrench w/
Phillips
Advertisement
Table of Contents
