Gsd File; Related Drive Parameters - YASKAWA SI-P3 PROFIBUS-DP Technical Manual

6 Related Drive Parameters

You can only use termination resistors without inductors as shown in
Mbps. Baud rates 1.5 Mbps and higher require termination with resistors and inductors as shown in
◆

GSD File

To facilitate network implementation, obtain a GSD file from one of the following websites depending on your
region:
U.S.: http://www.yaskawa.com
Europe: http://www.yaskawa.eu.com
Japan: http://www.e-mechatronics.com
Other areas: Check the back cover of these manuals.
For questions, contact Yaskawa or a Yaskawa representative.
Note:
Download the GSD file for YASKAWA AC Drive Option SI-P3. If you download an incorrect GSD file, this product will not operate as
a slave in the network.
6 Related Drive Parameters
These parameters set the drive for operation with the option. Make sure that the parameter settings in this table are
correct before you start network communications.
Note:
1. Hex.: MEMOBUS addresses that you can use to change parameters over network communication are represented in hexadecimal
numbers.
2. Parameter F7-16 [Timeout Value] to F7-79 [PZD10 Read]
• This setting is available in A1000 software versions PRG: 1021 or later.
26
Figure 5.25 PROFIBUS Cable Connection with Termination Resistors
Figure 5.26 PROFIBUS Cable Termination
Figure 5.26 for baud rates less than 1.5
YASKAWA SIEP C730600 82E PROFIBUS-DP Technical Manual
Figure 5.24.