Setting The Auto Ack Details - Furuno FS-5070 Operator's Manual

6. MENU OPERATION
6.11

Setting the AUTO ACK Details

The acknowledgement message may be sent automatically when you receive a message
which requires acknowledgement. You can also enable or disable it for position, polling and
test messages. Note that the automatic acknowledge is automatically disabled when RX
call contains error, as required by law. Further, automatic acknowledge is disabled in case
of OFF HOOK.
1. Press the #/SETUP key.
2. Choose USR SETUP, and push the ENTER knob.
3. Rotate the ENTER knob to choose AUTO ACK, and push the ENTER knob.
**
Auto ack setup
COMPLY TYPE
UNABLE REASON :
NO REASON GIVEN
POSITION MESSAGE: OFF
POLLING MESSAGE: ON
TEST MESSAGE: ON
Default: ON
Effective when 5/ACK/SQ key
OFF
is set for "AUTO ACK."
ON
OFF: Disables automatic
acknowledgement of
test call.
ON: Enables automatic
acknowledgement of
test call.
6-18
Default: ABLE
Effective when 5/ACK/SQ key is set for "AUTO ACK."
UNABLE
ABLE: Sends ABLE acknowledge automatically.
ABLE
UNABLE: Sends UNABLE acknowledge automatically.
Note: Automatic acknowledge is automatically disabled
when RX call contains error, as required by law.
Further, automatic acknowledge is disabled in case of
OFF HOOK.
**
: ABLE
Default: NO REASON
Rotate ENTER
NO REASON
knob to choose
BUSY
EQUIP DISABLE
MODE NOT USABLE
CH NOT USABLE
Sets reason for UNABLE.
Note: This menu is the same as manual
acknowledgement. EQUIPMENT
DISABLE is shown in calls when
EQUIP DISABLE is selected.
Default: OFF
Effective when 5/ACK/SQ key
OFF
is set for "AUTO ACK."
ON
OFF: Disables automatic
acknowledgement of
position request.
ON: Enables automatic
acknowledgement of
position request.
Default: ON
Effective when 5/ACK/SQ key
OFF
is set for "AUTO ACK."
ON
OFF: Disables automatic
acknowledgement of
polling request.
ON: Enables automatic
acknowledgement of
polling request.