Furuno FS-5070 Operator's Manual page 68

5. ROUTINE MESSAGE CALLING, RECEVING
*
Xmitted message
MAR-23-2006-23:01
ABLE ACKNOWLEDGEMENT
DESTINATION ID:
PRIORITY : ROUTINE TX: 2138.0 kHz
TELEPHONE
RESEND
2. Press the CANCEL key. You can now communicate with the party, over the
radiotelephone frequency specified or by the NBDP terminal unit.
Communicating by NBDP Terminal Unit
After acknowledging an individual call, do the following to communicate by NBDP Terminal
Unit. The control unit's display shows "OCCUPIED" and the Tx and Rx frequencies. The
message from the other station appears on your NBDP Terminal Unit.
1. After receiving the message from other station, type your message and then transmit it.
2. Press the function key F10 (BREAK) to disconnect the line.
Sending automatic acknowledge (ACK BQ) with comply type "UNABLE"
When an individual call is received and the automatic acknowledge feature is active (AUTO
ACK) and comply type is "UNABLE," the display shown below appears, indicating that the
auto acknowledge call (ACK BQ) with UNABLE is being sent.
Unable acknowledge
message in progress!
REASON: BUSY
DESTINATION ID
PRIORITY
DSC FREQ :
12577.5 kHz
TIME TO GO : 6S
It takes about seven seconds to transmit the call, after which the audio alarm sounds and
the following message appears.
Unable acknowledge
message transmitted.
CANCEL: STOP ALARM
DESTINATION ID :
PRIORITY
1. Press the CANCEL key to silence the alarm. The following display appears.
5-8
*
123456789
RX: 2138.0 kHz
10M10S
GO TO VIEW
:
121234567
: ROUTINE
121234567
: ROUTINE