2.11
Jumper Setting for Termination
For termination on the remote stations, open the remote handset hanger as shown be-
low. The default setting for J2 is "ON" (jumper block connected to pins 2 and 3). Con-
firm this setting. Re-connect the connector to the circuit board. Confirm that the plastic
washers are in the screw holes in the handset hanger then close the hanger. Do this
for all remote stations.
REMOTE
STATION
A maximum of four remote stations can be connected.
Unfasten six screws.
TRANSCEIVER
UNIT
JUNCTION
BOX
REMOTE
REMOTE
STATION
STATION
Disconnect connector
from circuit board.
15
2. CONNECTIONS
REMOTE
STATION
Short pins 2 and 3
for termination.