iFIT WEIDER 2980 X User Manual page 9

4. Attach the Front Leg (7) to the Base (1) with the
two M8 x 58mm Carriage Bolts (64) and two M8
Locknuts (58); do not tighten the Locknuts yet.
Next, hold the Leg Bumper (60) against the Front
Leg (7), and turn the Leg Bumper so that it is
angled upward (B).
Attach the Leg Bumper (60) with an M4 x 25mm
Self-tapping Screw (72).
5. Attach the Seat Frame (6) to the Upright (3) with
two M8 x 65mm Bolts (68), two M8 Washers (59),
and two M8 Locknuts (58); do not tighten the
Locknuts yet.
Attach the Seat Frame (6) to the Front Leg (7) in
the same way.
6. Slide the two Weight Bumpers (27) onto the
Weight Guides (21).
Next, orient the six Weights (22) so that the pin
holes (C) are on the bottom, and slide them onto
the Weight Guides (21).
Next, insert the Weight Selector Cap (23) into
the Weight Selector (24), and insert the Weight
Selector into the six Weights (22). Make sure that
the pin (D) on the Weight Selector is oriented
as shown.
Then, using a plastic bag to keep your fingers
clean, apply some of the included grease to the
indicated holes in the Top Weight (25), and slide
the Top Weight onto the Weight Guides (21).
4
B
72
60
58
5
68
68
6
68
59
58
59
6
C
9
7
58
1
64
59
68
59
3
7
21
Grease
25
D
24
23
22
27
58