iFIT WEIDER 2980 X User Manual page 12

13. IMPORTANT: Identify the two V-pulleys (46), the
nine Pulleys (48), and the two Thin Pulleys (47).
Tip: It may be helpful to refer to the EXPLODED
DRAWING near the end of this manual to
identify the locations of the pulleys.
Route the Arm Cable (54) over a V-pulley (46).
Attach the V-pulley (46), a Cable Trap (50), and
two Full Guards (41) to the Upright (3) with an
M10 x 63mm Bolt (75) and an M10 Locknut (56).
Make sure that the Cable Trap (50) is oriented
to hold the Arm Cable (54) in the groove of the
V-pulley (46).
14. Route the Arm Cable (54) under a Pulley (48).
Attach the Pulley (48) and two Half Guards (43)
to the Double U-bracket (63) with an M10 x 45mm
Bolt (81) and an M10 Locknut (56). Make sure
that the Half Guards are on the outside of the
U-bracket as shown.
15. Route the Arm Cable (54) over a V-pulley (46).
Attach the V-pulley (46), a Cable Trap (50), and
two Full Guards (41) to the Upright (3) with an
M10 x 63mm Bolt (75) and an M10 Locknut (56).
Make sure that the Cable Trap (50) is oriented
to hold the Arm Cable (54) in the groove of the
V-pulley (46).
13
3
48
46
14
81
15
75
41
46
12
56
41
46 50
41
54
47
54
48
56
43
43
63
50
41
54
3
75
56