iFIT WEIDER 2980 X User Manual page 13

16. Grease an M8 x 20mm Shoulder Bolt (65).
Attach the Arm Cable (54) to the indicated
Cable Pivot (39) with the M8 x 20mm Shoulder
Bolt (65) and an M8 Locknut (58). Make sure
that the cable end can pivot easily on the
Shoulder Bolt.
17. See the CABLE DIAGRAM. Identify the Low
Cable (53).
Route the Low Cable (53) through the Leg
Lever (8) and the Front Leg (7). Make sure that
the eyelet end (I) of the Low Cable is in the
location shown.
Then, attach a Pulley (48) inside the Leg Lever (8),
above the Low Cable (53), with an M10 x 68mm
Bolt (71), two M10 Washers (57), two 13mm
Spacers (52), and an M10 Locknut (56).
18. Attach a Pulley (48) inside the Front Leg (7),
above the Low Cable (53), with an M10 x 68mm
Bolt (71), two M10 Washers (57), two 13mm
Spacers (52), and an M10 Locknut (56).
16
Grease
65
17
8
57
52
56
53
I
18
57
52
56
13
54
39
58
48
7
52
57
71
48
7
53
52
57
71