iFIT WEIDER 2980 X User Manual page 10

7. Orient the Top Frame (4) so that the welded
support (E) is on the bottom.
Attach the Top Frame (4) to the Upright (3) with
two M8 x 65mm Bolts (68), two M8 Washers (59),
and two M8 Locknuts (58); do not tighten the
Locknuts yet.
Then, attach the Top Frame (4) between the
Weight Guides (21) with an M10 x 155mm
Bolt (74), two M10 Washers (57), two 19mm
Spacers (76), and an M10 Locknut (56).
See steps 3, 4, 5, and 7. Tighten the M8
Locknuts (58).
Arm Assembly
8. Grease the barrel of the M10 x 64mm Bolt
Set (85).
Orient the Leg Lever (8) so that the welded sup-
port (F) is on the side shown. Attach the Leg Lever
to the Front Leg (7) with the M10 x 64mm Bolt
Set (85). Do not overtighten the Bolt Set; the
Leg Lever must pivot easily.
9. Grease an M10 x 77mm Bolt (79).
Orient the Pivot Frame (5) so that the welded
tubes (G) are on the side shown.
Attach the Pivot Frame (5) to the Top Frame (4)
with the M10 x 77mm Bolt (79) and an M10
Locknut (56). Do not overtighten the Locknut;
the Pivot Frame must pivot easily.
Next, attach the two Arm Pins (40) to the Pivot
Frame (5) with two M4 x 19mm Self-tapping
Screws (69).
Insert the Arm Pins (40) into the two holes (H) in
the Upright (3).
7
59
4
E
58
8
85
8
F
9
56
69
5
40
G
10
68
59
76
57
56
57
58
3
21
21
Grease
7
85
4
H
79
Grease
3
69
40
74