iFIT WEIDER 2980 X User Manual page 16

26. Route the High Cable (55) upward through the Top
Frame (4) and over a Thin Pulley (47).
Attach the Thin Pulley (47) inside the Top
Frame (4) with the M10 x 68mm Bolt (71) used
in step 24, an 10mm Spacer (49), an M10
Washer (57), and an M10 Locknut (56).
27. Route the High Cable (55) over a Pulley (48) and
downward through the Top Frame (4).
Attach the Pulley (48) inside the Top Frame
(4) with an M10 x 68mm Bolt (71), two M10
Washers (57), two 13mm Spacers (52), and an
M10 Locknut (56).
28. Thread an M12 Nut (82) all of the way onto the end
of the High Cable (55).
Next, place a Large Washer (78) on top of the
Weight Selector (24).
Tighten the High Cable (55) into the Weight
Selector (24) until all of the slack is removed from
the cables.
Then, tighten the M12 Nut (82) against the Large
Washer (78).
Tip: If the High Cable (55) does not reach to
the Weight Selector (24), see step 22. If more
than two threads of the Low Cable (53) are show-
ing above the M8 Locknut (58), adjust the Locknut
so that only two threads of the Low Cable are
showing.
26
56
27
56
57
4
28
16
55
57
49
47
4
71
48
52
55
52
57
71
55
82
78
24