iFIT WEIDER 2980 X User Manual page 11

10. Grease an M8 x 50mm Shoulder Bolt (83).
Attach a Cable Pivot (39) to the Left Arm (10) with
the M8 x 50mm Shoulder Bolt (83) and an M8
Locknut (58). Do not overtighten the Locknut;
the Cable Pivot must pivot easily.
Next, wet the inside of a Large Foam Pad (42) with
soapy water. Slide the Large Foam Pad onto the
Left Arm (10).
Then, attach a Handle (11) to the Left Arm (10)
with two M10 x 25mm Screws (77) and two M10
Washers (57).
Assemble the Right Arm (9) in the same way.
11. Grease an M10 x 80mm Bolt (67) and two Arm
Bushings (44).
Attach the Right Arm (9) to the Pivot Frame (5)
with the M10 x 80mm Bolt (67), the two Arm
Bushings (44), and an M10 Locknut (56). Do not
overtighten the Locknut; the Right Arm must
pivot easily.
Attach the Left Arm (10) to the Pivot Frame (5)
in the same way.
Cable Assembly
12. IMPORTANT: See the CABLE DIAGRAM on
page 22. Cut along the dotted line, and lay
the CABLE DIAGRAM beside this manual for
reference while you assemble the cables and
the pulleys.
Identify the Arm Cable (54).
Grease an M8 x 20mm Shoulder Bolt (65).
Attach the Arm Cable (54) to the indicated Cable
Pivot (39) with the M8 x 20mm Shoulder Bolt (65)
and an M8 Locknut (58). Make sure that the
cable end can pivot easily on the Shoulder
Bolt.
10
9
11
44
9
44
Grease
12
11
83
Grease
39
10
58
42
11
57
57
Grease
67
5
56
58
39
54
Grease
65
77
10