Wexiodisk WD-90 DUO Installation And User Manual page 92

Operating instructions
ALARM MESSAGE
(62) HACCP ALARM
NO FLOW
DURING FINAL RINSE
MACHINE LOCKED
(39) FINAL RINSE ERR
SENSOR ERROR
FLOW METER BV02
CALL SERVICE
(40)
HACCP ALARM
FINAL RINSE DEFECT
PRESS RESET
(41) HACCP ALARM
FINAL RINSE DEFECT
MACHINE LOCKED
CALL SERVICE
(42) TIMEOUT WHEN
FILLING TANK
PRESS RESET TO
START FILLING AGAIN
(105) TIMEOUT WHEN
FILLING BREAK TANK
PRESS RESET TO
START FILLING AGAIN
(43)
TIMEOUT WHEN
HEATING TANK
PRESS RESET
(44)
LOW TEMPERATURE
IN TANK
PRESS RESET
(45) HACCP ALARM
HEATING OF TANK
DEFECT
PRESS RESET
(46) HACCP ALARM
HEATING OF TANK
DEFECT MACHINE
LOCKED CALL SERVICE
(47) LOW TEMP.
BEFORE FINAL RINSE
EXTENDED CHEMICAL
WASH
(48) HACCP ALARM
HEATING OF BOILER
DEFECT
PRESS RESET
(49) HACCP ALARM
HEATING OF BOILER
DEFECT. MACHINE
LOCKED CALL SERVICE
WD-90 DUO
ACTION
Contact service personnel!
Contact service personnel!
The alarm can be reset with the reset button, but a check should be made on
the water flow in the machine (to ensure the water taps to the machine's water
connection are open), and on the wash result after a completed wash cycle. If
the wash result is not satisfactory, contact service personnel.
The machine is locked when this alarm is activated. Check the water flow into
the machine,
- that the water taps to the machine's water connection are open,
- that there is nothing wrong with the water supply to the machine, etc.
Contact service personnel.
Check that water taps connected to the machine are open. Check that the level
pipe is in place and its rubber sleeve achieves a good seal with the tank bottom.
Reset the alarm by pressing the reset button.
Check that water taps connected to the machine are open and there are no
problems on the water supply to the machine. Reset the alarm by pressing the
reset button. Contact service personnel if the alarm will not go out.
Reset the alarm by pressing the reset button. Contact service personnel if the
alarm will not go out.
Reset the alarm by pressing the reset button. Contact service personnel if the
alarm will not go out.
Reset the alarm by pressing the reset button.
Contact service personnel!
Reset the alarm by pressing the reset button. Check the wash results after the
wash cycle has finished.
The alarm can be reset using the reset button, but service personnel should be
contacted as soon as possible.
Contact service personnel!
88
Rev. 2.0 (202204)