Wexiodisk WD-90 DUO Installation And User Manual page 72

Operating instructions
5.
6.
7.
8.
9.
10.
11.
WD-90 DUO
Rinse the filter tray (1) and cover plates (2) with water.
2
1
Remove the strainer (1) and cover plates (2). Remove any detritus which
has got stuck in the strainer holes.
If the machine is equipped with a drain pump (option), this is started by
pressing the button for normal wash (2).
Unhook the level pipe from its holder, give it a quarter turn and leave it po-
sitioned in the waste pipe. There should now be a slight gap between the
bottom of the tank and the rubber sleeve to allow the water to run out.
DON'T open the damper in the dividing wall! The granules will be flushed
out with the water into the drain in that case.
Refit the level pipe. Make sure the rubber sleeve achieves a good seal with
the bottom of the tank.
Refit the cover plates and the strainer.
Refit the rotating table. Make sure the screw heads on the shaft plate which
supports the rotating table end up in the holes on the bottom of the rotating
table's hub.
68
2
25-4-03-001
25-4-03-002
Rev. 2.0 (202204)