Connecting To The Serial Port; Connecting The Serial Interface Cable - Fujitsu 10 ppm User Manual

10/14 ppm page printer
Table of Contents

Advertisement

Secure
screws
User's Manual
(Example: serial interface)

Connecting to the Serial Port

Connecting to the serial port involves the following tasks:
• Connect the interface cable to the printer and your computer.
• Print out the status report to check the serial parameter default settings.

Connecting the Serial Interface Cable

To connect to the serial interface port, you need a cable correctly wired
for this printer and your computer. The cable must also have the proper
connectors. Your dealer or technical support person can supply you with
the proper cable.
The serial interface of this printer requires a null-modem cable with a
male DB25 connector at the printer side. Refer to your computer
documentation for the type of connector required by its serial port.
Notice:
Be sure that the printer is turned off before connecting the interface
cable.
Do not touch any connector contacts to avoid possible electrostatic
damage to the printer.
Installing an Interface Expansion Board
2. Hold the board with the parts
mounting side left. Slide the
board into the empty
interface slot using the
guides, and push it until it
stops. Secure the board by the
two screws supplied with it.
ENHANCING &
CUSTOMIZING
4-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

14 ppmPrintpartner 10vPrintpartner 14v

Table of Contents